Electrical Safety - DeWalt DC330 Traduction De La Notice D'instructions Originale

ENGLIS H
5 Finger guard
6 Blade holder
7 Guide roller
8 Shoe
9 Pendulum stroke selector
10 Shoe lever
11 Main Handle
12 Battery pack
13 Release buttons
14 Charger
15 Charging indicator (red)
INTENDED USE
Your DC330 jig saw is designed for professional
cutting of wood, steel, aluminium, plastic and
ceramic material at various work sites (i.e.,
construction sites).
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
These heavy-duty jigsaws are professional power
tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your D WALT charger is double insulated
E
in accordance with EN 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organization.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
40
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see technical data). The minimum conductor size is
2
1 mm ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENT
WARNING: Prior to assembly and
adjustment, always remove the battery
pack. Always switch off the tool before
inserting or removing the battery pack.
WARNING: Use only D
packs and chargers.
Inserting and Removing the
Battery Pack from the Tool (fi g. A)
1. Insert the battery pack (12) into the grip until it
clicks in place.
2. To remove the battery pack, press the two
battery release buttons (13) simultaneously and
pull the pack out of the grip.
Fitting and Removing a Saw Blade
(fi g. C)
The tool-free blade exchange system ensures quick
and easy changing of saw blades.
• Open the blade holder (6) by fully retracting the
blade latch (4).
• Insert the saw blade into the blade holder (6)
guiding the back of the blade into the groove of
the guide roller (7).
• Release the blade latch (4).
• To remove the saw blade, fully retract the blade
latch and pull the blade out of the holder.
SAW BLADES
Blade type Applications
Fine-toothed cutting blade for smooth straight cuts
Coarse-toothed cutting blade for fast straight cuts
Metal cutting blade for ferrous and
non-ferrous metals
Flush cutting blade 1) for finishing off cuts
up to a wall or edge.
1) Not available in all countries.
WALT battery
E