QSC I-82H Mode D'emploi page 5

Mounting
Stand Alone Mounting
If using the loudspeaker only, it can be set on any
appropriate surface. The cabinet will lean back at a
slight angle when set on a flat surface. Install the
four self-adhesive rubber feet on the cabinet bottom
to stabilize the loudspeaker and to help prevent it
from moving due to cabinet vibration at high output
levels.
On the back of the loudspeaker, near the bottom, is
a safety cable attachment point. Install a safety
cable strong enough to support several times the
weight of the loudspeaker assembly in the event it
may fall. The cable must be secured to a secondary
support point which is also strong enough to sup-
port several times the loudspeaker's weight.
IMPORTANT! ENSURE THAT THE
LOUDSPEAKER IS MOUNTED PROP-
ERLY AND A SAFETY CABLE IS
INSTALLED TO RETAIN THE LOUD-
SPEAKER IN THE EVENT OF A MOUNT-
ING FAILURE.
Pole Cup
The included pole cup will fit 1.375" and 1.500" (35
and 38 mm) diameter poles. To use the pole cup,
thread the adapter into the insert on the bottom of
the loudspeaker. Ensure the adapter is secure
before mounting on pole. Set the pole cup onto the
pole and make sure the pole seats fully into the
adapter. 1.500" (38 mm) poles will seat about 2" (50
mm) deep in the adapter, and 1.375" (35 mm) poles
will seat about 4" (100 mm) deep in the adapter.
Make sure the set screw retaining knob is in the
correct hole for the pole size used and that it is
tightened.
5/8"-27 Mic Stand Adapter
The mic stand adapter is intended for use with
large-base tripod microphone stands.
Ensure the mounting
surface and support-
ing structure are
appropriately strong enough to
support the loudspeaker
assembly and any potential
vibration or seismic activity.
Attach a safety cable to the
attachment point on the bot-
tom-back of the loudspeaker.
Ensure the safety cable, cable
attachment technique, secur-
ing hardware, and attachment
points are strong enough to
support several times the
weight of the loudspeaker in
the event of a primary-mount
failure.
EN
5