Electrical Safety - Black & Decker ASI500 Mode D'emploi

ENGLISH
Additional safety instructions for batteries and chargers
Batteries
Never attempt to open for any reason.

Do not expose the battery to water.

Do not expose the battery to heat.

Do not store in locations where the temperature may

exceed 40°C.
Charge only at ambient temperatures between 10°C

and 40°C.
Charge only using the charger provided with the

appliance/tool.
When disposing of batteries, follow the instructions

given in the section "Protecting the environment".
Do not damage/deform the battery pack either by

puncture or impact, as this may create a risk of injury
and fire.
Do not charge damaged batteries.

Under extreme conditions, battery leakage may occur.

When you notice liquid on the batteries carefully wipe
the liquid off using a cloth. Avoid skin contact.
In case of skin or eye contact, follow the instructions

below.
Warning! The battery fluid may cause personal injury or
damage to property. In case of skin contact, immediately
rinse with water. If redness, pain or irritation occurs seek
medical attention. In case of eye contact, rinse immediately
with clean water and seek medical attention.
Chargers
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Use your Black & Decker charger only to charge the

battery in the appliance/tool with which it was supplied.
Other batteries could burst, causing personal injury and
damage.
Never attempt to charge non-rechargeable batteries.

If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Do not expose the charger to water.

Do not open the charger.

Do not probe the charger.

The appliance/tool/battery must be placed in a well

ventilated area when charging.
6

Electrical safety

Your charger is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Never attempt to replace the charger unit with a regular

mains plug.
Labels on tools
The following symbols are shown on the tool:
Read the instruction manual before using the
inflator.
Do not expose the appliance to rain or high
humidity.
Before performing maintenance or cleaning
on the appliance, unplug the supply cord.
Do not leave the inflator unattended.
Features
1. Main power switch
2. LCD
3. Handle
4. High-volume pump deflate connection
5. Air hose with universal valve adaptor
6. Universal valve adapter
7. High-volume hose
8. 12 Vdc vehicle connector
9. Charger jack plug
10. High-volume pump inflate connection
11. Jack plug socket
12. LED light
13. Charger
14. Accessory storage
Fig. A
15. Charging LED