Installation Instructions; Starting To Use - Candy CMCH 154 EL88 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 34

3. INSTALLATION INSTRUCTIONS

STARTING TO USE

1.
If possible avoid placing the appliance near cookers, radiators or in direct sunlight as this will
cause the compressor to run for long periods. If installed next to a source of heat or
refrigerator, maintain the following minimum side clearances:
From Cookers
From Radiators
From Fridges
2.
Make sure that sufficient room is provided around the appliance to ensure free air circulation.
Ideally, A space of no less than 10cm must be left around the freezer, and ensure you allow
gaps as shown in the below diagram.
3.
The appliance should be located on a smooth surface.
4.
It is forbidden to use the refrigerator outdoors.
5.
Protection from moisture. Do not locate the freezer in moist space to avoid the metal parts
rusty. And do not spray water to the freezer, otherwise it will weaken the insulation and
causes current leakage.
6.
Refer to "Cleaning and Care" section to prepare your appliance for use.
7.
If the freezer is installed in unheated areas, garages etc., in cold weather condensation may
form on the outer surfaces. This is quite normal and is not a fault. Remove the condensation
by wiping with a dry cloth.
Before you starting to use the freezer, please check that:
1.
The interior is dry and air can circulate freely at the rear.
2.
Clean the interior as recommended under "TAKE CARE" section.
3.
Insert the plug into the wall socket, all LED lights, digital display light returned to normal
after 2s.; enter to modify status without any operation after 5s, automatically locked
4.
Set temperature range -24°C ~ -16°C.
4" (100 mm)
12" (300 mm)
4" (100 mm)
28

Publicité

Table des Matières
loading

Table des Matières