Charging The Batteries; Using The Device - Clatronic AKS 825 Mode D'emploi & Garantie

4....-05-AKS 825
After mounting the wall holder:
• Insert the AC adapter in a duly installed 230V/50Hz protective contact socket.
The charging LED lights up.
• If you want to charge the batteries, first remove the nozzle attachments and
then insert the device first into the upper bracket of the wall mounting.
• Then press the handle lightly until the device locks in place.
• The charging time is approximately 16 hours the first time, and then approxima-
tely 8 hours. Once the charging is over, unplug the AC adapter.
Unplug the device and fit on the desired nozzle. In order to start vacuuming you
have to press the ON/OFF switch (4) and keep it pressed. Once you have finished
or when the batteries are down, connect the vacuum to the charger as described in
„Charging the Batteries". Make sure that the plug is inserted.
Crevice nozzle:
Use for wet vacuuming:
• Always unplug the device before cleaning!
• Clean the casing with a dry cloth.
• The dust container can be released with the release knob (2) and then pulled
off from the top downwards.
• Remove the dust filter (10) by turning the insert anticlockwise (OPEN) and
tapping it out. After emptying the
container several times, it can also be cleaned in water. Dry well once you have
finished.
• Please reassemble the device in the reverse order.
This device has been tested according to all relevant current CE guidelines,
such as electromagnetic compatibility and low voltage directives, and has been
constructed in accordance with the latest safety regulations.
Subject to technical changes without prior notice!
22.02.2002 15:29 Uhr

Charging the Batteries

Using the Device

Nozzles
ideal for vacuuming corners and crevices, etc.
Please ensure that you always use the attachment
when vacuuming up liquids (insert the extension of
the attachment into the device until the nozzle is
flush).
Cleaning
Seite 23
23
GB