Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• If the connection cable of this device has been damaged, it must be
replaced with a special connection cable available from the manu-
facturer or its customer service.
• Do not use any mains adapter other than the one supplied.
• Do not vacuum combustibles or flammable liquids!
• Avoid vacuuming sharp or pointed objects!
• Never vacuum without the filter and filter cover installed.
Overview of the Components / Delivery scope
1 Dust container release button
2 Multi-function switch
3 Charging indicator lamp
4 Socket for mains adapter
5 Cable storage compartment with 12 V connection cable
6 Dirt collection container
7 Connector for accessories
8 Crevice nozzle, long
9 Crevice nozzle, short
10 Filter cover
11 Permanent filter
12 Brush attachment
13 Attachment for wet vacuuming
14 Power adapter
Unpacking the device
1. Remove the device from its packaging.
2. Check the delivery scope for completeness.
3. Check the device for any transport damage, in order to
prevent hazards.
NOTE:
In case of any transport damage, contact your dealer
immediately. Do not use a damaged device!
4. Remove the transport safety device from the multi-function
switch.
Instructions for Use
•
The device is especially suitable for quickly vacuuming
small amounts of dry dirt or dust.
•
It is furthermore suitable for vacuuming a limited amount of
wet dirt or liquids.
•
The device is operated via charged battery. Charge the bat-
tery using the power adapter provided. Direct power supply
via mains adapter is not possible.
•
If the rechargeable battery is empty, you can continue using
the vacuum cleaner via 12 V mains operation.
28
Multi-function switch (2)
Use the multi-function switch to select different operating
modes:
O Device off / charging mode
I
Device on in battery mode
II Device on in 12 V power supply mode with connection
cable
Nozzle attachments
The different nozzle attachments are easy to attach and to
remove.
Charging the battery
1. Turn off the device (switch position: O).
2. Connect the mains adapter to the socket (4).
3. Connect the mains adapter to a certified wall socket.
Charge the device for 12 hours before first-time use.
NOTE:
•
The indicator lamp lights up red during charging
operation.
The lamp does not indicate the charging status of
•
the device.
•
It is normal for the device to heat up during charging.
4. Stop any charging operation after a maximum of 12 hours.
CAUTION:
Always disconnect the plug from the wall socket after 12
hours of charging.
NOTE: on battery life:
Observe the following in order to prolong battery life:
•
Charge the battery only when it is almost empty.
•
Charge the device at an ambient temperature between 0°
and + 40°C.
Publicité
Table des Matières
