Overview Of Components; Putting The Appliance Into Operation - Clatronic HS 2767 Mode D'emploi & Garantie

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

5....-05-HS 2767

1 On/off switch

2 Locking button for the dust container

3 Handle

4 Eye for the hooking

of the shoulder strap (rear)

5 Dust containe

6 Eye for the hooking

of the shoulder strap (front)

7 Suction hose

Attachment of the Accessories

•

The large and the small brush nozzle can be attached to the vacuum cleaner

and - with the help of the crevice nozzle - to the suction hose.

•

The crevice nozzle can only be attached to the suction hose.

•

If you would like to use the suction hose together with the floor nozzle, the

upholstery/brush combination nozzle or the upright hoses, please attach the

handle to the hose first and then choose the desired accessory.

Putting the Appliance into Operation

1. Check whether the filter is inserted correctly on the front of the device.

2. Open the vacuum with the fastener (2).

3. Close the vacuum again by inserting the flap on the front in the relevant slot.

4. Close the vacuum by locking into place the upper flap.

5. Mount the desired accessory with or without the hose on the front of the vacu-

um. When using the hose make sure that the curved side is facing down.

Connect the device to a duly installed 230V, 50Hz protective contact socket.

To start the vacuuming, press only the On/Off (I/O) switch.

Since the device has a removable and washable filter, there is no need to buy

spare dust bags.

Nozzles:

Small brush nozzle:

Large brush nozzle:

Hose with crevice nozzle:

Upholstery/brush

combination nozzle:

Floor nozzle, switchable:

For smooth floors:

For carpets:

14.01.2003 8:37 Uhr