TEFAL Elegance 92040 Mode D'emploi page 6

In the event of a
There is no visible damage to your kettle
The kettle does not work or stops before boiling.
• Check that the kettle is plugged in properly.
• The kettle has been operated without water or scale has
accumulated, triggering the safety system to prevent dry operation:
leave the kettle to cool and then fill with water. Use the switch to turn
it on: the kettle starts working again after about 15 minutes.
The water tastes of plastic
This usually occurs when the kettle is new. Throw away the water the
first few times you use it. If the problem persists, fill the kettle to
maximum, add two teaspoonfuls of bicarbonate of soda.
Boil and throw away the water. Rinse the kettle thoroughly.
If your kettle has fallen, if it leaks, or if the cord, the plug
or the base of the kettle are visibly damaged
Return your kettle to your Tefal After-Sales Service Centre, the only
organization authorized to repair it. See warranty conditions and list of
centres in the booklet supplied with your kettle.
The type and serial number are indicated on the bottom of your model.
This product has been designed for domestic use only.
Any professional use, inappropriate use or failure to comply
with the instructions, the manufacturer accepts no responsibility
and the guarantee will not apply.
of accidents in the home
For a child, even a slight burn may sometimes be serious.
As they grow up, teach your children to be careful with hot fluids in the
kitchen.
Place the kettle and cord towards the back of the working surface, out
of children's reach.
If an accident occurs, rinse the burn immediately with cold water
and call a doctor if necessary.
problem
Prevention
Tefal reserves the right
to modify the
characteristics or
components of its
kettles at any time, in
the interests of
consumers.
• Do not use the kettle.
No attempt should be
made to dismantle the
appliance or the safety
systems.
• If the base of your
kettle is assembled with
screws and if the power
cable is damaged, it
must be replaced by the
manufacturer, its after-
sales department or a
person with similar
qualifications for safety
reasons
• If the base does not
include any screws, the
power cable cannot be
replaced. If the cable,
the base or the
connector are damaged,
the base must be
replaced completely.
• To avoid accidents,
never carry your child
or baby when you are
drinking or carrying a
hot drink.