Numark PARTY MIX Guide D'utilisation page 5

Rear Panel
1
1. Master Output (RCA): Use standard RCA cables to connect this output to speakers or
an amplifier system.
2. USB: This USB connection sends and receives audio and control information from a
connected computer.
3. Party Ball Mode: Press this button to cycle between the different lighting modes for the
Party Balls.
i. Serato DJ Lite color-controlled (default when powered on)
Note: In this mode, you can select from three lighting control patterns in the Serato
DJ Lite Setup > Mixer menu.
ii. Serato DJ Lite beat-controlled
iii. Fixed-timing random
iv. All on
v. Off
4. Party Balls: When activated, these lights will illuminate according to the current Party
Ball Mode setting.
Front Panel
1. Headphone Output: Connect headphones
to this 1/8" (3.5 mm) jack for monitoring the
signal. The headphone volume is controlled
using the Cue Gain knob.
3
4 4 4
2
1
5