Denon Professional DN-200WS Guide D'utilisation page 9

STA Mode
To set up DN-200WS in STA Mode:
1. Make sure DN-200WS is in AP Mode (as described earlier in
2. On your wireless device, open your web browser and go to http://192.168.0.1.
The Settings page will appear.
3. Click the STA Network Select field to select the desired wireless network.
4. Click the STA Security Mode field to select the desired wireless network's
security mode.
Note: If you select WPA, WPA2, WPA-Personal, or WPS, you will need to
enter a password.
5. Click the STA Network Password field and enter the password for the
desired wireless network. (Check the Display Password checkbox to
reveal the password, or uncheck it to hide it again.)
6. Click Submit (under the Device Name field). You will see a webpage
confirming the new settings were sent to DN-200WS.
7. Disconnect DN-200WS from its power source, and then reconnect it. It will
automatically enter STA Mode using the new wireless network information.
The STA Mode Light will turn on.
Your wireless device is now connected to DN-200WS. Play audio on your
wireless device to send it from DN-200WS's outputs to your loudspeakers
or mixer.
Important: After you have gone through Steps 3–6 once, DN-200WS will
remember that information whenever you enter STA Mode. When you want
to use STA Mode with a different wireless network, repeat Steps 1–9.
Note: To learn how to enter the settings for each mode (wireless network,
password, etc.), see the following Settings Page section.
AP Mode).
9