Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. AP Mode Light: This LED flashes while DN-200WS is entering AP
Mode and lights solidly when it is in AP Mode. In this mode, DN-
200WS and your wireless device are connected directly over DN-
200WS's own wireless network. See
6. STA Mode Light: This LED flashes while DN-200WS is entering STA
Mode and lights solidly when it is in STA Mode. In this mode, DN-
200WS and your wireless device are connected in an existing wireless
network. See
7. Level Knob: Turn this knob to adjust the volume level of the audio
signal sent to the outputs.
8. Reset Button: Press this button to reset DN-200WS to its default
status. It will automatically enter AP Mode.
9. Outputs (Balanced XLR): These outputs send the audio signal from
your wireless device. Use XLR cables to connect these outputs to your
loudspeakers, mixer, etc. See
10. Outputs (Unbalanced 1/4" / 6.35 mm): These outputs send the audio
signal from your wireless device. Use standard 1/4" (6.35 mm) cables
to connect these outputs to loudspeakers, mixer, etc. See
more information.
4
Operation
to learn more.
Operation
Setup
for more information.
to learn more.
Setup
for
Publicité
Table des Matières
