Using The Drive - Panasonic CF-VEBC21U Instructions D'utilisation

Using the Drive

„
Setting a Disc
Turn on the computer.
A
Press the eject button (A) and slowly pull out the tray.
B
Insert/Remove the disc.
C
• To insert
Set the disc with the label side up and press the center of the
disc until it clicks in place.
• To remove
Press on the center spindle (B) and carefully lift up the edge of
the disc.
Close the tray.
D
Do not press the eject button.
NOTE
●
The drive indicator
●
To remove a disc when the computer is powered off, insert a pointed object (e.g., the bent-out tip of a
paper clip) into the emergency hole (C). Pushing it to the end allows the tray to come out.
●
If the vibration of the drive is excessive, check the disc.
●
For AutoPlay CD/DVD:
• If an AutoPlay CD/DVD does not start after the computer resumes from sleep or hibernation, remove
the disc from the drive and then reinsert it after waiting 15 seconds.
• An AutoPlay CD/DVD may start during file access depending on the status of the disc.
●
When playing back video from a disc, playback may not be smooth in some conditions.
„
Power-saving Mode
If the drive is not accessed for 30 seconds, the drive motor will automatically be shut down to reduce the
power consumption. When the drive is accessed again, the drive motor is turned on. In this case, reading of
the disc data will take approximately 30 seconds.
„
To play DVD-Video or MPEG2 files
Install the DVD playback software using "DVD Drive Utility Disc".
For information on how to install the software, refer to "Software Guide" with "DVD Drive Utility Disc".
„
Region Code Setting
DVD-Videos are allocated to region codes according to where they are sold. To play a DVD-Video, the DVD
disc and the drive must have the corresponding region code.
e.g.,
For U.S.A. and Canada: "1"
For Europe: "2"
on the computer will blink while the disc is being accessed.
A
C
B
11