Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-1114-001.book Page 16 Tuesday, March 9, 2010 1:07 PM
16 | English
When grinding, tilt down the spark guard 9
as far as possible. Sparking occurs when
grinding metal.
Regularly check the clearance between the
workpiece support 10 as well as the holder
of the spark guard 8 to the grinding wheel,
and readjust as required. The clearance to
the grinding wheel may not exceed 2 mm.
When the clearance is larger, you are not suf-
ficiently protected against sparking. The
workpiece can be drawn in by the rotational
motion of the grinding wheel and lead to in-
juries.
Guide the workpiece only against the
switched-on machine and do not switch the
machine off until after having removed the
workpiece. The workpiece can move sudden-
ly.
Never apply the workpiece laterally against
the rotating grinding wheel, and always
grind from the front. The workpiece can be
drawn out of your hand through the rotation-
al motion of the grinding wheel and lead to
injuries.
Never reach into the running grinding wheel
of the machine. This can lead to serious inju-
ries.
Do not stop coasting grinding wheels by ap-
plying lateral pressure to them. The work-
piece can be drawn out of your hand through
the rotational motion of the grinding wheel
and lead to injuries.
Wear a work apron. Pay attention that other
persons are not put at risk from sparking.
Remove flammable materials in close vicini-
ty. Sparking occurs when cutting metal.
Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with
internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fit-
ted in its place by an authorised customer serv-
1 609 929 V05 | (9.3.10)
ice agent. The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Functional Description
Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Intended Use
The machine is intended for sharpening tools as
well as for grinding and deburring metal.
The machine may only be used for short-time op-
eration (60 min. max).
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Cover
2 Clamping nut
3 Clamping flange
4 Mounting flange
5 Grinder spindle
6 Blade guard
7 On/Off switch
8 Holder for the spark guard
9 Spark guard
10 Workpiece support
Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
Bosch Power Tools
Publicité
Table des Matières
