Tools Required - Cooper Lighting Solutions Archeon Small Instructions D'installation

Installation Instructions - Archeon
INSTALLATION

Tools Required

9/16" socket or wrench, #2 Phillips head screwdriver,
flathead screwdriver, and electrical wiring tools as needed.
1. With housing lying on a smooth, soft surface open the
access door by rotating the front door latch 1/4 turn.
2. The door may be removed by opening approximately
120° and lifting off the hinge and by disconnecting the
wire harness quick disconnects.
N ote: If optional lanyard is supplied, the door should not be
removed. (Figures 1 & 2.)
3. Using a 9/16" socket, loosen the two pipe clamp bolts
enough to allow mounting arm (not included) to slide
onto leveling steps. (Figures 1 & 2.)
N ote: A bird guard is provided pre-cut to accommodate
1-1/2" diameter mounting arms. When using larger
diameter mounting arms, remove the punch out
section of the bird guard. (Figure 3.)
4. Lift the housing into place and position end of mounting
arm onto leveling steps so that housing is level. Care
must be taken so arm does not inadvertently strike
internal components. (Figure 4.)
5. If using a 1-1/2" pipe, remove the clamp bolts and
flip clamp so that pipe size is visible from the top.
The clamp must be reversed for the smaller pipe size
option. (Figure 2.)
6. Using a 9/16" socket, tighten the clamp bolts to
14-16 ft-lbs.
Door Latch
(2) Bolts 3/8"
2" Pipe Mount
Figure 1.
2
COOPER LIGHTING SOLUTIONS
Small
TM
Bird Guard
Pipe Clamp
Leveling Steps
IB521005EN Installation instructions
Door Latch
(2) Bolts 3/8"
Figure 2.
Figure 3.
Bird Guard
Pipe Clamp
Leveling Steps
1.5" Pipe Mount
Cutout for Larger
Diameter Arm