Olympia A230 Plus Mode D'emploi page 24

Laminator / 4-in-1 Set A 230 Plus / A330 Plus
Trimmer & Corner Cutter
Trimmer & Corner Cutter
Trimmer
The trimmer is located on the underside of the laminator and must be pulled out
before it can be used.
1. Set the trimmer down on a level, stable working base.
2. Slide the cutting head to one side of the guide rail
3. Place the material to be cut under the guide rail and press the rail downwards.
Use the visual positioning aids on the trimmer to help produce a clean cut.
4. Draw the cutting head along the guide rail to the other side of the trimmer.
5. Remove the material cut.
Corner Cutter
Model A330 Plus only: The corner cutter is located on the underside of
the laminator and must be pulled out before it can be used.
1. Set the corner cutter down on a level, stable working base.
2. Lay a corner of the material to be cut in the opening of the corner cutter.
3. Press the top half of the corner cutter down.
4. Remove the material cut.
24