Cold Lamination - Olympia A230 Plus Mode D'emploi

Laminator / 4-in-1 Set A 230 Plus / A330 Plus

Cold Lamination

Cold Lamination
For cold lamination, the laminating pouch is coated with a special adhesive. Unlike
hot lamination, cold lamination bonds the foil not with heat, but with pressure.
Cold lamination is suitable for non-permanent sealing. The cold laminating pouch
can usually be removed from the laminated material without leaving any residues.
1. Set the laminator down on a level, stable working base.
Make sure the On/Off switch is switched to OFF before plugging the lami­
nator into a power socket.
2. Plug the laminator power cable into an easily accessible power socket.
3. Switch the On/Off switch to the setting COLD. The POWER and READY indi­
cator lamp light up.
4. The drive motor for rolling starts up. The laminator is ready for operation.
If you have used the laminator for hot lamination shortly before you want to cold-
laminate, let it cool down for around 15 minutes.
5. Remove the protective foil from the laminating pouch.
6. Place the material to be laminated inside the laminating pouch. For an optimal
lamination result, leave an all-round spacing of 3 to 5 mm from the edges of
the pouch.
If the material to be laminated is not of a standard paper size, also place
an insert inside the laminating pouch that corresponds with the size of the
laminating pouch. Place the material to be laminated at the front edge of
the closed end of the laminating pouch.
7. Feed the prepared laminating pouch with the closed side first, keeping it
straight, into the infeed of the laminator.
The laminator automatically draws the laminating pouch in and ejects it on the out­
put side.
22