Trouble Shooting - Springlane Hanno Mode D'emploi

Trouble shooting

If the device does not work properly, please check the following steps:
1. Check if the manual was followed precisely and correctly.
2. Check the following table for possible reasons.
3. Check if all fuses are working.
problem
The operating buttons do
not light up, the device
does not work.
The operating buttons light
up, the device does not
work.
The device stops after a
longer period of mixing.
The resulting mixture is not
fine enough.
28
• Place the mixing container onto the motor head and
plug the power cable into the socket.
• Press the container down again to reactivate the
security switch.
• Ensure that the lid of the accessory and the
accessory itself is properly locked in place before
you place the container on the motor block.
• Place the mixing container onto the motor head and
plug the power cable into the socket.
• Ensure that the lid of the accessory and the
accessory itself is properly locked in place before
you place the container on the motor block.
• Turn back the dial controller to position "OFF".
Continue with the desired speed/functions.
• The overload protector protects the motor from
damage.
• Unplug the power cable and let the high-
performance blender cool down for 30 min. before
connecting It again.
• The blender can be overloaded by too many or too
large ingredients. Try again with a smaller portion
and mix multiple portions if needed.
• Ingredients should be chopped into pieces no larger
than 2 cm.
solution