AEG HK956600XB Notice D'utilisation page 13

Incorrect cookware position:
5.4 FlexiBridge Max Bridge
mode
To activate the mode press
see the correct mode indicator. This
mode connects all sections into one
cooking zone. To set the heat setting use
one of the left side control bars.
Correct cookware position:
To use this mode you have to place the
cookware on the four connected
sections. If you use cookware smaller
than three sections the display shows
and after 2 minutes the zone switches off.
Incorrect cookware position:
until you
5.5
This function allows you to adjust the
temperature by moving the cookware to
a different position on the induction
cooking area.
The function divides the induction
cooking area into three areas with
different heat settings. The hob senses
the position of the cookware and sets the
heat setting corresponding with the
position. You can place the cookware in
the front, middle or rear position. If you
place the cookware in the front you get
the highest heat setting. You can
decrease the heat setting by moving the
cookware in the middle or to the rear
position.
ProCook function
Use only one pot when you
operate the function.
ENGLISH 13