Kemper 65435KW15 Mode D'emploi page 11

installing in order to keep the distance between the heater
and the wall.
18. CAUTION: some parts of this product can become very
hot and cause burn. Particular attention has to be given
where children and vulnerable people are present.
1. Remove all the packaging material and make sure that the appliance is in good condition. If you have any
doubt, do not use the appliance and contact our After-Sales Service. Keep the packaging material (staples,
nylon bags, etc.) out of the reach of children. Before turning the fan heater on, check that the voltage and
frequency of the power socket are compatible with those indicated in the product technical plate.
2. This appliance must be connected to an approved mains socket that complies with the safety regulations on
electrical systems for civil purposes. The electrical system must be specific for the appliance rated voltage
and must be equipped with an earth cable.
3. The appliance must be used only for its intended use, that is, as a heater for domestic heating. Any use other
than its intended purpose shall be deemed to be improper and hazardous.
4. The manufacturer shall not be held responsible for damages derived from misuse of this appliance, do not
assuming any responsibility in case of incorrect use that will decline any warranty.
5. The appliance has dangerous components that must be kept out of the reach of children.
6. Make sure the power plug can be disconnected at any time.
7. Do not lay the power cord under a carpet. Do not cover the power cord with a cover or similar elements.
Pay attention not to place the power cable where it is likely to get into people's way.
8. Never connect the power cord to extensions or triple plugs. Do not pull or damage the power cord. Before
any maintenance operations, disconnect the plug from the mains socket.
9. If the appliance does not work properly, immediately turn off the fan heater and disconnect it from the
mains socket. For repairs, contact a technical support centre authorised by the manufacturer, and require
that original spare parts be used. Using parts that do not conform to the product may seriously compromise
its correct operation.
10. Attention, do not use the appliance, if the lamp is broken.
11. In order to unplug the appliance, select the OFF button and disconnect the plug from the power socket.
USER INSTRUCTIONS
Wall installation with bracket
• Remove all the packaging material. Check if plug and cable are not damaged.
• Before drilling the wall, in order to install the appliance, be sure it complies with all the following minimum
safety distances, from walls and ceilings. (fig. 1)
• Fix the supplied L bracket to the wall in a stable and safe position
• Assemble the heater to the bracket
•
Adjust the angle of the lamp: recommended 45 ° angle (fig. 3).
• Connect the appliance to the electricity network, when the unit is turned on it will take a few seconds before
start up heating. Check the correct functioning for the first 10-15 minutes.
fig.1
ATTENTION: The heater has to be fixed on walls, where there are no combustible materials positioned,
directly above the appliance or in any case in the immediate vicinity. Otherwise, place the product at a
minimum distance of 1 m from the ceiling, from the lateral walls and from other thermo-sensitive materials.
ISTR65435KW15-20_REV.04_ 07/2020
GENERAL PRECAUTIONS FOR USE
mounted on the wall using the wing nuts and bolts provided (fig. 2).
fig. 2
using the supplied screws.
fig. 3
65435KW15-20
11/12