Electrical Connection; Terminal Blocks - Argo AUAH Notice D'installation

4.3 - ELECTRICAL CONNECTION

• Remove the front panel (fig.1) .
NOTE:
The panel is connected with two wires to the electrical junction box. Be careful not to pull the wires and, in
case, disconnect them .
• Remove the cover of electrical junction box to access the terminal blocks (fig. 2) .
• Let the electrical wires pass first in the wire grommets on the back of the unit and then in the wire glands
placed over the electrical panel (fig. 3) .
• Connect the power line and interconnecting wires to the unit and secure them with the wire glands .
FRONT VIEW
L N
1 2
Fig. 1
Fig. 3

TERMINAL BLOCKS

3 4 5 6 7 8 C1 C2
Fig. 2
FRONT VIEW
REAR VIEW
9 10
C3 C4 C3 C4 C3 C4
11
11 12 13 14 15 16 17 18
EG
19 20 21