Remove from underneath the vacuum cleaner the pin (A) and spring pin (B) that fasten the filter to the
shaking lever.
Lift the filter complete with support.
Loosen the clamp and remove the support ring with seal.
Remove the knots and take out the pocket filter. Fit the new filter, put everything back together
carefully and fit the cap back on.
Important!
All the material trapped by the filter and the filter itself must be disposed of through authorised channels
in the country where the vacuum cleaner is used.
The container locking operation must be performed by one person only, who must lower the back side lever
with both hands.
Caution!
Hand crushing hazard!
Uzin Utz Tools GmbH & Co. KG | D-74360 Ilsfeld | Ungerhalde 1 | Tel. +49 (0)7062-91556-0 | Fax +49 (0)7062-91556-41 | E-Mail info@wolff-tools.com | Internet
A
B
www.wolff-tools.com