Dremel 670 Mode D'emploi Et Consignes De Sécurité page 9

Operating Instructions
TYPES OF CUTS
The saw blade provided with your attachment
isfor both cross cuts and rip cuts. Ripping is
cutting lengthwise, with the grain of the
wood. Cross cutting is cutting against the
grain.
Your rotary tool should be running at the set
speed before starting the cut, and turned off
only after completing the cut.
Primarily for use on wood or wood-like mate-
rials. Other materials may cause blade to wear
out prematurely. Not for use on metal or
masonry.
DIRECTIONAL GUIDE
Feed direction for the rotary tool is right to
left only.
For a straight 90° cut, use the directional
guide on the left side of the guard to guide
your cut. This guide also shows feed direc-
tion. Make sample cuts in scrap lumber to
verify line of cut. For minimum splintering,
place the good side of the material face
down.
Maximum depth of cut is 1/4". Not for cutting
radii, curves or bevels.
16
DV-2610917718, Page: MUL (VAA), downloaded at: 2016.01.05_00:20:06, by PT-RT/MKP1_Fulvio.Camarotto
Always be sure that
! WARNING
hands or fingers do not
interfere with the free movement of the
lower guard.
Maintain a firm grip. Never force the rotary
tool. Use light and continuous pressure.
When cutting across the grain, the fibers of
the wood have a tendency to tear and lift.
Advancing the saw slowly minimizes this
effect.
Clean lower guard
WARNING
!
frequently to assure a
rapid return of lower guard.
This attachment is not
WARNING
!
intended for abrasive cut
off wheels. Standard Dremel wheels will
not fit on mandrel.
17