Dremel 670 Mode D'emploi Et Consignes De Sécurité page 8

Step 1. Mount attachment onto your rotary
tool. Be sure rotary tool is unplugged and the
switch is in the OFF position.
Step 2. Press the shaft lock button on your
rotary tool. Unscrew the screw from the
mandrel and remove.
Step 3. Pushing the guard foot up on the
attachment, place the blade onto the mandrel
arbor, making sure the arrows on the blade are
facing out and the blade is resting flat on the
shoulder of the mandrel arbor. Make sure the
blade teeth point in the same direction as
arrows on upper guard.
While retracting the lower guard, check
operation and condition, including the spring.
14
DV-2610917718, Page: MUL (VAA), downloaded at: 2016.01.05_00:20:06, by PT-RT/MKP1_Fulvio.Camarotto
Step 4. Press the shaft lock button on your
rotary tool. Replace the screw and tighten
securely.
15