emerio SI-120718.2 Mode D'emploi page 6

SI-120718.2
PARTS IDENTIFICATION
1. Temperature regulator
2. Water inlet
3. Indicator light
4. Steam control knob
5. Soleplate
6. Heating base
7. Water tank
8. Self-clean position
BEFORE INITIAL USAGE
Remove all packaging material. Make sure the appliance is unplugged and the temperature regulator is set at
position "OFF".
Fill water into the water inlet opening up to the max level marked on the water tank. For this, use the measuring
cup. Do not use chemically de-calcified water.
Insert the power plug in to a designated outlet and set the temperature regulator on the highest temperature
setting. After the indicator light goes off, set the steam control knob to position "
on an old piece of cloth to remove possible residue.
With first use, these can be slight odour or smoke. But this is harmless and only of short duration. Make sure
there is adequate ventilation.
OPERATION
Before selecting the temperature, read the instruction manual for the iron or the care advice on the tag of
the clothing.
Note: If there is no care advice on the piece of clothing, then you should begin ironing with the lowest
temperature. With lower temperatures, there will be less steam.
Caution: Synthetic fabrics can melt.
OFF
.
..
...MAX
DRY IRONING
1. Connect the iron to a suitable mains supply outlet.
2. Ensure that the steam control knob is in position "0" for dry ironing.
3. Select the setting on the temperature regulator.
4. When the indicator light goes off, the required temperature is reached. The iron is ready for use.
5. To turn off the iron, turn the temperature regulator counter-clockwise to position "OFF", set the iron upright,
and pull out the power plug.
Nylon
Wool, silk
Linen, cotton, highest temperature
- 5 -
EN
" for steam ironing and iron