Installation Instructions; Prepare Built-In Microwave/Oven Combination; Remove Oven Door(S) - Jenn-Air JMW2430DP Instructions D'installation

Electrical Connection
To properly install your oven, you must determine the type
of electrical connection you will be using and follow the
instructions provided for it here.
Oven must be connected to the proper electrical voltage,
■
amperage and frequency as specified on the model/serial/
rating plate. See the following illustration.
A. Model/Serial/Rating Plate
Models rated from 7.3 to 9.6 kW at 240 volts (5.4 to
■
7.4 kW at 208 volts) require a separate 40-amp circuit.
A circuit breaker is recommended.
■
Connect directly to the fused disconnect (or circuit breaker
■
box) through flexible, armored or nonmetallic sheathed,
copper cable (with grounding wire). See "Make Electrical
Connection" section.
Flexible conduit from the oven should be connected
■
directly to the junction box.
Prepare Built-In Microwave/
Oven Combination
1. Decide on the final location for the oven. Locate
existing wiring to avoid drilling into or severing
wiring during installation.
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
2. To avoid floor damage, set the oven onto cardboard prior
to installation. Do not use handle or any portion of the front
frame for lifting.
3. Remember to remove bottom vent from the foam packing
on top of oven.
4. Remove the shipping materials and tape from the oven.
5. Remove the hardware package from inside the bag
containing literature.
6. Remove and set aside racks and other parts from inside
the oven.
7. Move oven and cardboard close to the oven's final location.
4
A

INSTALLATION INSTRUCTIONS

Do not cut the conduit. The length of conduit provided
■
is for serviceability of the oven.
A UL listed or CSA approved conduit connector must
■
be provided.
If the house has aluminum wiring, follow
■
the procedure below:
1. Connect a section of solid copper wire to the ends
of the flexible conduit leads.
2. Connect the aluminum wiring to the added section
of copper wire using special connectors and/or tools
designed and UL listed for joining copper to aluminum.
Follow the electrical connector manufacturer's
recommended procedure. Aluminum/copper connection
must conform with local codes and industry-accepted
wiring practices.
For power requirements, refer to the following table:
Model Voltage
JMW2430D
JMW2427D 208
JMW3430D
JMW2430D
JMW2427D 240
JMW3430D
* Amperage values noted above are for information purposes only:
The units are rated in watts.

Remove Oven Door(s)

IMPORTANT: Use two hands to remove oven door.
1. Prior to removing the oven door, prepare a surface where
you will place it. This surface should be flat and covered with
a soft blanket, or use the corner posts from your packaging
material.
2. Open the oven door.
3. Locate the oven door hinge locks in both corners of the
oven door, and then rotate the hinge locks toward the oven
door to the unlocked position. If the door hinge lock is not
rotated fully (see illustration B), the door will not remove
properly.
A. Oven door hinge lock
in locked position
Amperage Amperage
(L1)* (L2)*
31 28
33 30
A
B. Oven door hinge lock
in unlocked position
Rating
(kW)
6.6
8.0
B