Bosch PMF 10,8 LI Notice Originale page 17

OBJ_BUCH-1170-006.book Page 17 Wednesday, October 12, 2016 11:17 AM
Accessory
HM-Riff segment
saw blade
HM-Riff delta plate Mortar, concrete remain-
HM-Riff grout and
mortar remover
Scraper, rigid
BIM serrated seg-
ment saw blade
Mounting/Replacing the Application Tool/Accessory
If required, remove an already mounted application tool/
accessory.
For removing the application tool/accessory loosen the screw
10 with the hex key 11 and remove the tool.
Mount the application tool/accessory (e.g. plunge cut saw
blade 9) in such a way on the tool holder 7 that the openings
of the tool engage into the cams of the tool holder.
For a safe and fatigue-free working position it is possible to
position the application tools/accessories in any snap-in posi-
tions on the tool holder. Position the tool in such a way that
the depressed centre points downwards (marking on the tool
is readable from above, see figure on the graphics page).
Use the screw 10 to fasten the application tool/accessory.
Tightly fasten the screw 10 with the hex key 11.
 Check the tight seating of the application tool/accesso-
ry. Incorrect or not securely fastened application tools/ac-
cessories can come loose during operation and pose a haz-
ard.
Bosch Power Tools
Material Application
Grouting joints, soft wall Cutting and separating close to edges, in corners or hard to
tiles, glass-fibre reinforces reach areas;
plastic and other abrasive example: removing grouting joints between wall tiles for
materials repair work, cutting openings in tiles, gypsum boards or
plastic
Rasping and sanding on hard surfaces;
ders, wood, abrasive ma- example: removing mortar or tile adhesive (e.g. when
terials replacing damaged tiles)
Mortar, grouting joints, Removing grouting joints from wall and floor tiles as well as
epoxy resin, glass-fibre re- removing mortar and joint adhesive (also in right-angled
inforces plastic and other corners)
abrasive materials
Carpets, coverings Scraping on hard surfaces;
example: removing carpet and tile adhesive
Insulation material, insula- Cutting soft materials
tion panels, floor panels,
sound insulation panels,
cardboard, carpet, rub-
ber, leather
Mounting/Replacing a Sanding Sheet on the Sanding
Plate
The sanding plate 12 is fitted with Velcro backing for quick
and easy fastening of sanding sheets with Velcro adhesion.
Before attaching the sanding sheet 13, free the Velcro back-
ing of the sanding plate 12 from any debris by tapping against
it in order to enable optimum adhesion.
Position the sanding sheet 13 flush alongside one edge of the
sanding plate 12, then lay the sanding sheet onto the sanding
plate and press firmly.
To ensure optimum dust extraction, pay attention that the
punched holes in the sanding sheet match with the holes in
the sanding plate.
To remove the sanding sheet 13, grasp it at one of the tips and
pull it off from the sanding plate 12.
You can use all sanding sheets, fleece pads/polishing cloth
pads of the Delta 93 mm series of Bosch accessory program.
Sanding accessories, such as fleece pads/polishing cloth
pads, are attached to the sanding plate in the same manner.
English | 17
1 609 92A 1ZZ | (12.10.16)