Changing The Air Filter; Troubleshooting; Refrigerator Operation - Whirlpool W8CRNGMXD00 Instructions D'utilisation

5. Replace the burned-out bulb with a 15 watt, T25 appliance
bulb with an E14 base.
NOTE: This appliance bulb can be ordered from our service
department or from an appliance replacement parts supplier.
A
A. Light shield
B. Light shield lock
6. Replace the light shield.
7. Plug in refrigerator or reconnect power.

Changing the Air Filter

Your refrigerator has a FreshFlow air filter, located in the vent grille
in the inside wall above the crisper cover.
The FreshFlow air filter fights odors produced by food and is up to
15 times more effective than baking soda, which helps to maintain
a cleaner environment inside the refrigerator.
IMPORTANT: The disposable air filter should be replaced every
6 months because it gradually loses its odor-fighting properties.
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
The refrigerator will not operate
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Power cord unplugged? Plug into a grounded 3 prong outlet.
Is outlet working? Plug in a lamp to see if the outlet is
working.
B

TROUBLESHOOTING

to possibly avoid the cost of a service call.
In the U.S.A., www.whirlpool.com

Refrigerator Operation

Air Filter Status
The Filter icon on the control panel display will let you know
when it is time to change the air filter. The status indicator bar
below the icon will decrease and gradually disappear, and the
indicator will start blinking.
After replacing the air filter, press and hold the Temperature
and Adjust controls simultaneously for 3 seconds. The status
indicator bar will appear on the display. See "Using the
Controls."
NOTE: You do not have to wait for the indicator bar to
disappear; you can reset the status tracking feature as
needed.
Replacing the Air Filter
To order a replacement air filter, contact Whirlpool using the
assistance or service information following the warranty.
1. With your index finger, press the upper tab of the filter
cartridge and then pull gently until the cartridge is released.
2. Insert the new filter into the cavity and push gently until it
snaps into place.
In Canada, www.whirlpool.ca
Household fuse blown or circuit breaker tripped? Replace
the fuse or reset the circuit breaker. If the problem continues,
call an electrician.
Control(s) on? Make sure the refrigerator control is on. See
"Using the Control(s)."
New installation? Allow 24 hours following installation for the
refrigerator to cool completely.
NOTE: Adjusting the temperature control(s) to coldest setting
will not cool the refrigerator more quickly.
The motor seems to run too much
Your new refrigerator may run longer than your old one due to its
high-efficiency compressor and fans. The unit may run even
longer if the room is warm, a large food load is added, the door is
opened often, or if the door has been left open.
11