Krups XP52 AUTOMATIC Mode D'emploi page 75

KR_XP52-AUTOMATIC_EO_NC00026254-01 29/11/11 15:36 Page71
Problems
The appliance does
not work
The steam nozzle
does not froth the
milk.
12. END-OF-LIFE ELECTRONIC PRODUCT
Environmental protection first!

Leave it at a local civic waste collection point.

When disposing of it, take it to a local civic waste collection point.
HELPLINE:
If you have any product problems or queries, please contact our Customer Relations Team first for expert help
and advice:
0845 330 6460 - UK
(01) 677 4003 - ROI
or consult our website - www.krups.co.uk
Possible causes
The pump was unprimed
due to lack of water.
The detachable water
compartment is not properly
clicked in place.
The Claris cartridge has
been replaced but not
primed.
The steam nozzle is blocked
or scaled up.
The milk is not fresh enough.
The shape of the container
is not appropriate.
The milk is not cold or fresh
enough.
The steam nozzle is not
properly clipped onto the
arm.
The auto-cappuccino
accessory is poorly fitted.
Solutions
Fill the water tank and reprime the pump (see
paragraph 5). Avoid completely emptying the tank.
Click the tank into place by pressing firmly.
See paragraph 5.
Descale the steam nozzle (see paragraph 9) or
unblock it using a needle.
Use fresh cold milk.
Use a small stainless steel jug.
Use very cold, very fresh milk. Try using a different
brand of milk.
Clip it firmly onto the arm (fig.18.1, 18.2).
Insert it firmly into the articulated arm.
English
71