Qlima PGWH1010 Manuel D'utilisation page 55

• The manufacturer is not responsible for any harm or damage if attention is
not paid to the points described above.
• Do not twist the flexible tubing or the hose.
• Connect the water hose water-in and water-out as shown in fig 7.
• Mount the shower head bracket using the 2 screws provided in the package
show in figure 8.
BATTERY:
Install the two pieces D cell batteries as shown in fig 5. NOTE the "+" and the "–"
to be in correct position!
Before use: check for any GAS LEAKS
1. Close the gas container.
2. Make sure there is sufficient ventilation.
3. Prepare a bucket of soapy water.
4. Open the gas container.
5. Brush the soapy water on all fittings and connections of the gas circuit.
6. If there is a gas leak, bubbles will rise up from the location of the leak.
7. If a leak is found, close the gas container.
8. Tighten the fitting and the metal rings of the connection.
9. Open the gas container and repeat the procedure again.
USE
For outdoor use only.
WARNING:
Make sure the appliance cannot get wet. Protect from water and rain.
1. Turn the regulation knob on the gas container into the open position.
2. Release the knob and turn it to the position corresponding with the desired
amount of heat.
3. Open the water tap.
4. The product is now ready to use.
5. See fig, 1: control panel.
M = Turn on the appliance with button M
B = more / less heat/gas
H = more / less water flow
WARNING:
The water from the appliance maybe very hot. Always carefully check the water
temperature. Risk of burned skin!
6. Most hot water: Turn B (gas flow) clock wise to max. and turn B counter
clockwise to min.
7. Reduce the temperature of the water: turn H counter clockwise to min. and
turn B clockwise to max.
4
55