Assembling The Appliance - Qlima PGWH1010 Manuel D'utilisation

instructions for use. Incorrect use and/or not
following the instructions can lead to dan-
gerous situations causing severe injuries to
humans and/or serious damage to property.
• Warning: Do not interfere with any of the
sealed components.
• Conversion to other gases shall be carried
out by a qualified installer, as described in
the installation instructions.
• Contact an autorised gas appliance installer
for installation, maintenance and adjusting
of the appliance
• Maintenance to this appliance should be
done 2 times per year by an autorised gas
appliance installer
• This heater is intended and able to operate
OUTDOORS within the ambient tempera-
ture 1° and 60°C. Do not use for the supply
of drinking water. This water heater is not
dedicated for providing (hot) drinking water
and is not dedicated for delivering sanitary
water. Use only for cleaning materials.
• Use rain water or water from other natu-
ral source such as a lake. Use a pump + fil-
ter to supply the water to the heater at the
correct pressure and without dirt/pollution.
Alternatively place a water reservoir at a
higher level than the water heater in order
to have the water coming into the water
heater at sufficient pressure.

ASSEMBLING THE APPLIANCE

Before connecting the low-pressure regulator, please follow the instructions
provided with the low-pressure regulator.
The manufacturer is not responsible for any harm or damage if attention is not
paid to the points described above. Do not twist the flexible tubing or the hose.
Gas hose to be minimal 80 cm and max 150 cm. Internal diameter between 8 and
12 mm. Make sure that the gas hose applies with local legislation and standards.
53