Directions For Use - Qlima PGWH1010 Manuel D'utilisation

INSTALLATION REQUIREMENTS
•
•
•
•
•
INSTALLATION METHOD:
Carefully remove your appliance from the box and check the contents for any
damage. Mount the product as shown in fig 6.

DIRECTIONS FOR USE

If you have any doubts concerning the heater, please contact qualified service
personnel. Keep all packaging material out of the reach of young children. Before
connecting the low-pressure regulator, please check and read the following:
The appliance should only be powered by propane-butane in a container with
a maximum weight of 15 kg. Connect the low-pressure regulator with a fixed
calibration of maximum 30 mbar that complies with EN 16129:2013. The hose
should be according to national standards. For correct connection, follow the
instructions provided with the low pressure regulator.
•
•
•
Before connecting the low-pressure regulator to the gas container, make sure that
the gas container is closed and that there are no open flames (i.e. a lit oven) in the
place where you are working. Connect the low-pressure regulator according to
the user instructions that are provided with the low-pressure regulator. Check for
gas leaks: see relative section.
•
•
•
•
•
•
•
4
54
The flame-check window of the water heater shall be at eye level of the user.
Make sure all electrical lines or electric equipment is at least 400mm away from
the appliance in all directions.
Clearance distances: see fig. 2 and fig. 3.
The product must be positioned vertical with the gas- and water connections
mounted perfectly downwards.
Make sure the product is fixated thoroughly so it cannot fall.
Connect the regulator to the gas container.
Connect the correct end of the gas hose to the regulator (see fig. 4).
Connect the other end of the gas hose to the appliance (see fig 4). Use the 3
in 1 multi country connector if required. (refer to separate delivered picture
manual related to the 3 in 1 multi country connector).
To replace the gas container, make sure that the gas container is closed
(follow the user instructions provided with the low-pressure regulator).
Make sure that there are no open flames or other sources of heat in the area
in which you are working.
Only change the gas cylinder in a amply ventilated area, away from any
ignition source (candle, cigarettes, other flame producing appliances, ...).
In addition it is recommended that the gasket seals of the regulator and the
flexible rubber hose be checked to ascertain their condition. If you have any
doubt concerning the condition of the hose or the seals, replace them.
Make sure that you do not damage the connection or any other components.
Never turn the gas container upside down in order to make full use of the
contents. This may release liquid residues left in the container that damage
the appliance Irreparably.
For disconnection or connection of the low-pressure regulator, always follow
the user instructions provided with the regulator.