S&P ARTIC-405 PM GR Notice D'utilisation page 9

INSTRUCTIONS FOR ASSEMBLY (FIG.1)
1. Loosen the holding bolt on the back grill (clockwise) and the fan blade holding bolt (anti-
clockwise) from the motor shaft.
2. Mount the back protective grill on the motor head, ensuring that the 3 holes located in the
grill coincide with the three pins on the front part of the motor. Fix the grill to the motor using
the holding bolt for the back protective grill.
3. Place the fan blade on the motor shaft, adapting the slots in the central part of the fan blade
to the pins on the motor shaft and tighten the holding bolt for the fan blade.
4. Check the fan blade by turning it manually. Ensure that there is no friction with the safety
counter bolt. The fan blade must turn freely, if not, repeat the previous steps.
5. Mount the front protective grill by introducing the hook, located on the upper part of the
same, into the back protective grill. Unite the two gratings and press until they are well
joined within the plastic ring.
6. Close the security clip located on the bottom part of the front grill and tighten the screw.
MOUNTING THE FAN ON THE WALL (FIG.2)
• Ensure that the wall where the fan is to be mounted is strong enough to support the weight
and oscillations of the fan.
• Fix the metallic support to the wall by using the screws and rawl plugs supplied with the
appliance.
• Place the fan on to the metallic support by locating the slots on the back part of the appliance.
USING THE FAN AND CONTROL FUNCTIONS
After checking the voltage, connect the fan to the mains.
To start the fan you can use the controls or the control cable (A).
• Velocidad de funcionamiento:
Mediante el mando de control superior o tirando
del tirador (A), usted podrá seleccionar tres
velocidades distintas de funcionamiento,
0
Slow
Medium
• Timer:
With the lower control switch, you can select how long you wish
the fan to operate (0-180 minutes).
OFF
Fast
9