Whirlpool ADN 350S Mode D'emploi page 6

This appliance is not designed for the storage of explosive substances such as
–
aerosol cans with a flammable propellant.
It is prohibited to store petrol and other flammable liquids near the appliance.
–
The appliance should be used only for storing foodstuffs
–
Requirements for the connection to the mains:
The appliance should only be connected to an earthed socket installed in
–
accordance with the regulations. This product complies with all binding CE
labelling directives. The earthed electrical socket by which the appliance is
connected to the mains should be in an accessible place. It is a legal
requirement that the appliance is properly earthed. The manufacturer will not be
held liable for any damage or injury which may result from the failure to fulfil this
requirement.
The frequency and power of the electricity supply must conform to the general
–
data parameters of the appliance as it is shown in the product label.
WARNING: If the supply cord is damaged: to avoid the exposure to danger,
–
always have faulty cable be replaced only by the manufacturer, by our customer
service or by qualified person and with a cable of the same type.
Do not use adapters, multiple sockets and two-wire extension leads. If it is
–
necessary to use the extension lead, it must be equipped with a protection ring
and a single socket and must have a VDE/GS safety certificate.
When positioning the appliance, be careful that the electrical cord isn't
–
squeezed in order to avoid its damage. Do not store heavy objects such as
cooling devices, furniture or other devices next the appliance in such a way that
they could squeeze and damage the electrical cord. This can cause a short
circuit and a fire.
Make sure that the plug of the electrical cord is not squeezed by the back wall
–
of the appliance or otherwise damaged. A damaged plug can be the cause of a
fire!
CAUTION! If the installed interior lighting diode (LED) lamp for the cooling
–
device is not functioning, contact the maintenance and repair representative for
replacements. LAMPS CAN BE REPLACED ONLY BY THE MAINTENANCE
AND REPAIR REPRESENTATIVE.
Requirements for safe use:
Once the appliance is unpacked, make sure that it is complete, that the body
–
and the electrical cord aren't damaged. It is forbidden to use a technically
damaged appliance.
5