After Ironing - Bosch Sensixx'x DA70 Notice D'utilisation

The descaling liquid can be obtained from our
after-sales service or specialist shops :
Accessory code
(After-sales)
311144
10
Drip protection
lf the temperature is set too low, the steam is
automatically switched off to avoid dripping.
There may be an audible click when this occurs.
Fabric-protection
11
soleplate cover
(Model dependent)
The fabric-protection is used for steam-ironing
delicate garments at maximum temperature
without damaging them.
Use of the protector also does away with the need
for a cloth to prevent shine on dark materials.
It is advisable to irst iron a small section on the
inside of the garment to see if it is suitable.
To attach the fabric protector to the iron, place
the tip of the iron into the end of the fabric
protector and press the rear of the protector
upward until you hear a click. To release the
fabric protector, pull down on the clip at the rear
and remove the iron.
The fabric-protection soleplate cover may be
purchased from the customer service or specialist
shops :
Accessory code
(After-sales)
575494
12
StoreProtect
(Model dependent)
1. D o not use the protector during ironing or
when the iron is connected to the mains!
Unplug the iron from the mains socket, empty
the water tank, set the steam regulator to
the position and put the iron into the store
protector.
2. D o not touch the store protector when the iron
is attached, as it could get hot.
Name of accessory
(specialist shops)
TDZ1101
Name of accessory
(Specialist outlets)
TDZ1550
3. N ever rest the iron on the protector out of the
rubber pads when the soleplate is still hot.
4. T he protector can be used on a horizontal and
stable surface, or in a vertical position ixed to
a wall by means of two bolts (one at the tip and
another one at the rear).
The power cable may be coiled loosely around
the heel of the iron.
To attach the store protector to the iron, place
the tip of the iron into the front rubber pad of the
protector and press the rear of the iron until you
hear a click.
To release the store protector, pull down on the
clip at the rear and remove the iron.
Accessory code
(After-sales)
575960
13
After ironing
• Switch the steam regulator from
and back again several times (self- cleaning).
• Empty the tank.
• Hold the iron with the point down and shake
lightly.
• Store standing on the rear, not on the base.
• Do not wrap the power cord too tight!
14
Cleaning
Attention ! Risk of burns !
Always unplug the appliance from the mains
supply before carrying out any cleaning or
maintenance operation on it.
• If the iron is only slightly soiled, pull out the
plug and allow the soleplate to cool down. Wipe
the housing and the soleplate with a damp
cotton cloth only.
• If the cloth is synthetic, it may melt due to
thehigh temperature on the soleplate, switch off
the steam and rub off any residue immediately
with a thickly folded, dry cotton cloth.
• To keep the soleplate smooth, you should
avoid hard contact with metal objects. Never
use a scouring pad, or chemicals to clean the
soleplate.
• Never decalcify the tank or treat it with
detergents or solvents, otherwise the iron will
drip water whilst steaming.
Name of accessory
(Specialist outlets)
TDZ1750
to "max"
17
B OS CH