Cleaning; Troubleshooting - Bosch MaxoMixx MSM89 Série Mode D'emploi

en

Cleaning

Caution!
The bottom of the receptacle you use must
not have any bumps or steps in it.
■ Clean all parts before using for the first
time.
X Fig. B
■ Completely unwind the mains cable.
■ Place the blender foot on the base unit
and lock into position.
■ Plug the mains plug into the mains.
■ Place the food in the blender jug or
another tall receptacle.
The appliance works better if there is some
liquid in the ingredients.
W Risk of electric shock!
Only immerse the blender foot into the food
as far as the marking Í or there will be
a risk of electric shock!
■ Set the required speed with the speed
control (Fig. B-5). It is recommended
using a low speed setting for liquids,
hot food and for mixing (e.g. muesli
into yoghurt). The high speed settings
are recommended for processing more
solid foods.
■ Firmly hold the hand blender and jug.
■ Switch on the hand blender by pressing
the required On button.
When switching on the hand blender, hold it
at a slight angle to prevent it from „sticking"
to the bottom of the blender jug. The hand
blender remains switched on as long as the
On button is pressed.
To prevent the ingredients from splashing,
do not press the On button until the blender
foot has been immersed in the ingredients.
Always switch off the hand blender before
taking it out of the ingredients.
■ Release the On button after processing.
After using the appliance:
■ Pull out the mains plug.
■ Press the release buttons and remove
the blender foot from the base unit.
12
Cleaning
The appliance must be thoroughly cleaned
after each use.
Important information
The appliance requires no maintenance.
Thorough cleaning protects the appliance
from damage and keeps it functional.
W Risk of electric shock
Never immerse the base unit in liquids and
do not clean in the dishwasher. Before
cleaning the appliance, pull out the mains
plug! Do not steam-clean the appliance!
Caution!
Surfaces may be damaged. Do not use
abrasive cleaning products.
Note: The plastic parts may become
discoloured when processing certain
ingredients such as red cabbage or carrots,
however this can be removed with a few
drops of cooking oil.
■ Pull out the mains plug!
■ Wipe the base unit with a damp cloth
and then wipe dry.
■ The blender jug and lid can be cleaned
in the dishwasher.
■ Clean the blender foot in the dishwasher
or with a brush under running water.
■ Dry the blender foot in an upright
position (blender blade face up) so that
any trapped water can run out.
Note:
Appliances with a spiral cable:
Never wind the cable round the appliance!

Troubleshooting

Problem
Appliance switches off during use.
Remedy
The overload protection device is activated.
■ Switch off the appliance and pull out the
mains plug.
■ Leave the appliance to cool down for
approx. 1 hour in order to deactivate
the overload protection device.
■ Switch the appliance on again.
If the fault cannot be eliminated, please
contact customer service.