Operation; Cleaning And Care; Descaling - Unold onyx Notice D'utilisation

Masquer les pouces Voir aussi pour onyx:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13

oPeratioN

1. Remove the kettle from the base.
2. Press the opening button ÖFFNEN/AUF on
top of the handle. The lid is released and
can be opened.
3. Fill the kettle with at least 0.5 liters of
water. Do not fill the kettle with more than
1.7 liters of water ("Max" marking).
4. Close the lid until by pressing the black
button on the lid until it clicks into place.
The locking prevents accidental opening
during pouring out.
5. Place the kettle level on the base.
6. Switch on the kettle by pressing the key
upwards. The inside of the kettle will be
lighted (control lamp function). The kettle
cannot be switched on if it is not properly
seated on the base.The kettle cannot be
switched on if it is not properly seated on
the base.
7. When the water boils, the appliance
automatically shuts off.

cleaNiNg aND care

1. Allow the appliance to cool before cleaning it.
2. Before cleaning, always turn off the appliance and
unplug it from the power supply.
3. Do not immerse the base, power cord or
kettle in water or other liquids or wash them
in the dishwasher.
4. Wipe off the base and the kettle with a damp
cloth and a little dishwashing detergent. Do
not use any abrasive scouring agents, steel

DeScaliNg

1. The lime scale filter has to be cleaned
regularly. Please empty the kettle completely
and allow it to cool off. Carefully remove the
filter from the pour spout. Clean the filter
carefully with a soft brush under running
water. You can also place the filter in a bowl
with a descaling solution. Then rinse the
filter with clear water and insert it in the
pour spout.
2. To keep the appliance operating efficiently
and to prolong its service life, it should
be descaled regularly, depending on the
hardness of your water.
12
8. Whenever you take the kettle off the base,
the appliance is automatically switched off,
even if the water is not yet boiling.
9. Of course you may also push the switch into
the „O"-position to interrupt heating.
10. If you want to boil more water, please allow
the appliance to cool off for a few minutes.
11. Boiling water can cause scalding. therefore,
please handle the appliance with care when it
contains hot water.
12. The appliance features boil dry protection.
When operated without water or with
excessive scaling, the appliance shuts off
automatically. If this happens, please allow
the appliance to cool off briefly before filling
it with water again or descale the appliance
as described in the chapter "Descaling" on
page 12.
wool, metal objects, hot cleaning agents or
disinfectants, since they can damage the
appliance.
5. The appliance must be completely dry on
the outside before you use it again.
3. To descale the kettle, fill it no more than
half full with a solution of half water and
half household vinegar. Bring the liquid to a
boil and leave it in the kettle for a while.
4. Pour the descaling solution out of the
kettle.
5. Then fill it with fresh water and bring to a
boil. Pour this water out as well. Then rinse
the kettle at least twice with clear water.
6. Of course, you can also use commercially
available descaling products; please follow
the instructions on the package.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

18016

Table des Matières