Safety Instructions; Before The First Use - Steba LB 5 Mode D'emploi

Generally
This appliance is for private use only and must not be used commercially. Please read
the instruction manual carefully and keep it at a safe place. When the appliance is
given to another person the instruction manual should be passed to that person, too.
Only use the appliance as described in the instruction manual and pay attention to
the safety information. No liability for damages or accidents will be accepted, which
are caused by not paying attention to the instruction manual.

Safety instructions:

∙ The appliance must only be plugged into a socket and used according the technical
data given on the rating label
∙ Only use the appliance when the power cord or the appliance has no damage.
Check before each use.
∙ Place the power cord in that way that the appliance can not fall down.
∙ This appliance is not intended for use by persons (including children)
with reduced physical, sensory, or mental capacities, or lack of experience
and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety
∙ Children should be supervised to ensure that they do not play with the appliance or
the packaging.
∙ The appliance is not intended to be operated by means of an external timer or
separate remote control system.
∙ Unplug the appliance after each use or in case of a malfunction.
∙ Never pull at the power cord. The power cord must not be torn over edges and it
must never be squeezed.
∙ The power cord must not be touched with wet hands.
∙ Never leave the appliance unattended during the use.
∙ The appliance must not be stored outside or in a damp environment.
∙ Never immerse the appliance into water.
∙ The appliance should be switched off when the water tank is empty or when it
should not be used. If the appliance is not used for longer time, it should be un-
plugged and cleaned.
∙ After any malfunction the appliance should not be used anymore, e.g. after is fell
down or was damaged in any other way.
∙ The manufacturer takes no responsibility for wrong usage which is caused by igno-
ring the instruction manual.
∙ Any repairs at the appliance, e.g. exchange a damaged power cord must be done
by an authorized service person, to avoid any danger.
∙ When any abnormal smell occurs is it important to switch off the appliance and
contact the service.
∙ Do not place the opening for the mist against any electrical appliances or sockets.

Before the first use:

After a longer non use of the appliance the water filter should be placed for 20 min
in salty water. The bottom of the water tank and the water basin is with a nanosilver
structure and reduces the growth of bacteria. Positive ions make the water softer.
10
Important note - Filling in of water:
The tank cap with the water filter is opened by turning the tank cap counter-clockwi-
se (it is located under the water tank No. 9). Then you can fill in cold water in the filler
neck. Tightly close the tank cap with the water filter. Place the water tank correctly
on the support No. 15 so that it can properly work.
Start-up of the device:
Connect the plug with the mains socket. A beep sound is heard, and the display
shows the current room temperature and humidity, and standby
in the top left corner of the display. The water tank is lit by a blue LED. The standby
operation consumes 1 watt.
Press the Power button . The standby symbol disappears from the display, and
your air humidifier starts immediately. 1-6 bars are shown on the display, and water
vapour comes down from the water tank through the directed nozzles (No. 1) which
you may turn by 360 degrees.
When no or not enough water is left in the tank, just a red drip is flashing on the
display, and 10 beep sounds can be heard from the device. Refill water as described
in (Filling in of water). The device re-starts immediately after the full water tank has
been placed in position again.
After approx. 1 minute, the display lighting (-50%) changes over to sleep mode to
save energy. As soon as you press a button, the lighting of the display returns.
Humidity
By pressing the Humidity button (setup flashes on the display) you can adjust the
humidity in a range from 45 to 90%. As soon as the device has reached the adjusted
humidity in the room, it is switched off. When the humidity drops below the adjusted
one, it is automatically switched on again.
Please note:
In the program Humidity, your air humidifier controls the water vapour automatically.
By means of the Max/Min button, you change the water vapour and so the quantity
of sprayed water.
1 - 9 bars are displayed at maximum. Consumption 30 watts
1 - 3 bars are displayed at minimum. Consumption 20 watts
Your air humidifier always starts with the medium program; 1 – 6 bars are displayed.
Consumption 25 watts
The percentage of water mist in a room and the air temperature are together the
relative humidity. The correlation between mist and air is varying at the different
temperatures. The higher the temperature is, the less water mist can be in the air.
is indicated in red
11