Working With The Machine; Acoustic Warning Signals; Accessories - Festool OSC 18 Notice D'utilisation D'origine

English
CAUTION
There is a risk of injury and negative impact
on health associated with using tools that
are not supplied or recommended by Fes­
tool.
Damage to machine caused by increased vi­
bration load
► Always use original Festool tools.
CAUTION
Risk of crushing hands and fingers
If you switch on the power tool when the
clamping lever is open, the clamping lever is
closed by spring force. Open clamping jaws
are spring-loaded.
► Never switch on the power tool with the
clamping lever open.
► Never reach into the area around the
clamping jaws.
Removing the insertion tool [3a]
► Open the clamping lever [3-1].
The insertion tool drops down.
► Close the clamping lever until it clicks into
place.
If the power tool switches on without
the insertion tool, the clamping jaws
[3-2] may open. This makes a pop­
ping sound.
Inserting the insertion tool [3b]
If the clamping jaws [3-2] are open, open and
close the clamping lever [3-1].
► Close the clamping lever until it clicks into
place.
► Push the device onto the tool until it clicks
into place.
The tool can be offset in 30° incre­
ments and secured in the most effec­
tive working position.
The protection (against accidental
contact) on the saw blade may be­
come twisted if wear has occurred,
see fig. [4]
9

Working with the machine

Observe the following information:
– Only guide the power tool towards the
workpiece when it is switched on.
– A significant increase in the force required
to advance the machine and slow working
16
progress are indicators that the blades are
worn.
– Hold the power tool by the gripping sur­
face [1-3] with both hands to ensure safe
guidance. Do not cover the cooling air
openings [1-4] with your hand. Otherwise
there is a risk of the machine overheating.
– Do not hold the power tool by the battery
pack.
– Always secure the workpiece in such a way
that it cannot move during machining.

10 Acoustic warning signals

If the power tool switches off due to one of the
following operating states, a warning signal
sounds when switching on the tool and the
power tool switches off again.
Battery pack not accepted
– Insert the correct battery pack model.
Battery pack empty
– Change the battery pack.
– Charge the battery pack.
Battery pack fault
– Change the battery pack.
– Use the charger to check that the battery
pack is fully functional once it has cooled
down.
Battery pack overheated
– Let the battery pack cool down.
Power tool overheated
– You must allow the power tool to cool down
before starting it up again.
Power tool fault
– Contact a Festool service workshop or spe­
cialist dealer.
Power tool jammed
– Eliminate the cause of the jam.
If the power tool switches of when it
becomes jammed, no warning signal
sounds.

11 Accessories

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
Always use original Festool tools and accesso­
ries. Using low-quality tools or accessories
from other manufacturers may increase the
risk of injury and cause seriously unbalance the