Technical Data; Parts Of The Device; Operation; Switch On/Off - Festool OSC 18 Notice D'utilisation D'origine

4

Technical data

Cordless oscillator
Motor voltage
Speed
Oscillation angle
Weight as per EPTA procedure
01:2014:
5

Parts of the device

[1-1] Clamping lever for changing tools
[1-2]
On/off switch
[1-3] Gripping surface
[1-4]
Cooling air openings
[1-5]

Capacity display

[1-6] Capacity display button on battery
pack
[1-7] Button for releasing the battery pack
[1-8]

Battery pack

[1-9]

Speed control

[1-10] Tool
[1-11] Adapter*
[1-12] Depth stop with sliding shoe*
[1-13] Rotary depth stop*
[1-14] Dust extraction device*
[1-15] Positioning aid*
* Accessories shown or described are not al­
ways included in the scope of delivery.
The illustrations specified are located at the be­
ginning and end of the operating instructions.
6

Operation

6.1

Switch on/off

The switch [1-2] is an on/off switch (I = ON, 0 =
OFF).
When the battery pack is empty, or if
there is a power failure or the mains
plug is removed, move the on/off
switch immediately to the Off position.
This prevents uncontrolled restarting.
7 Battery pack
► Inserting the battery pack [2a]
OSC 18
18 V
10,000–19,500 rpm
2 x 2.0°
1.6 kg
► Removing the battery pack [2b]
7.1 Capacity display
The capacity display [1-5] indicates the charge
of the battery pack for approx. 2 seconds after
the button [1-6] is pressed:
Recommendation: Charge the battery pack
*
before any further use.
Further information about the battery
pack and charger can be found in the
corresponding operating manual.
8

Settings

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
8.1 Speed control
You can use the adjusting wheel to continuous­
ly adjust the speed within the speed range (see
Section Technical data). This enables you to op­
timise the speed to suit the respective material.
Please also note the specifications on the tools.
8.2 Changing the insertion tool
CAUTION
Hot and sharp tools
Risk of injury
► Do not use any blunt or faulty insertion
tools.
► Wear protective gloves.
► Carefully remove the protective resin from
the cutting edge of new tools.
English
70‑100%
40‑70%
15‑40%
< 15%
*
15