ArmorAll AA255 Manuel D'utilisation page 7

GENERAL ASSEMBLY INSTRUCTIONS
1
6
11
WARNING:
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE SURE THE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VACUUM. TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the power head off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank. Make sure you have all contents as listed on page 6 (Fig. 4).
5. Your vacuum comes ready for dry vacuum cleaning. If the cloth filter is not installed, refer to page 11 for installation
instructions (Fig. 5 & 6).
6. For wet vacuum cleaning, remove the reusable cloth filter and install the supplied foam wet filter. See page 12 for the
foam wet filter installation instructions (Fig. 7).
7. Place the power head back on the collection tank aligning the top section with the latches, and snap into place (Fig. 8
& 9).
8. Insert the larger end of the hose into the vacuum port on the collection tank (Fig. 10).
9. Choose the desired attachment and insert onto the end of the hose (Fig. 11).
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade wider than the other). This plug will fit
in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact
a qualified electrician to install the proper outlet. Do not change the plug in any way. Double insulation
need for the three-wire grounded power cord and grounded power supply system.
2 3
7 8
4
9
7
5
10
eliminates the