Chris Benz DEPTHMETER Mode D'emploi page 32

9. LOG MODE
CHANGING THE LOG DISPLAY
Every dive makes the watch memorize the following 8 types of log data automatically,
which can be recalled in the order of I, II, III and IV as shown on the right side.
When the watch is switched from the chro-
nograph mode to log modepressing button
(M) log I is displayed.
Each time button (A) is pressed, the log
display is changed to the next in the order
of I, II, II and IV.
ATTENTION: On rare occassions, even if the water sensor senses traces of water and the watch
is switched to the dive mode (Ready state) however, log I display may fail to change to log II
display automatically. In case this happens, press button
60
Only when log I is displayed, the display is
automatically changed to log II after 2 second
without pressing button (A).
(A) to change the display.
9. LOG MODE
Log Log
I II
Number of Maximum
dives depth
(A)
Month and
Dive time
date
Log Log
III IV
Dive start Average
time depth
(A) (A)
Dive end Lowest
temp.
time
61