Finishing The Installation - D-Link DUB-E100 Guide D'installation

Check Your Package Contents
DUB-E100
Installing the DUB-E100
A. Plug the DUB-E100's USB cable into an available USB port on your computer.
B. Windows will detect new hardware and prompt you for the Drivers, which can be found
on the CD provided. Please follow onscreen instructions.
driver installation, please refer to the Manual on the CD.
C. Attach an Ethernet cable to the Ethernet port on the DUB-E100.
D. Attach the other end of the Ethernet cable to your network switch, hub, or router.

Finishing the Installation

Installation of the DUB-E100 is complete. The LINK LED should be solid green, indicating a
good physical connection between the DUB-E100 and the network. The TX/RX LED indicates
when data is being transmitted or received. If both LEDs are unlit, there may be a problem with
the physical connection. Check the cables between your DUB-E100, the computer, and the
network. Verify that your network switch, hub, or router is powered on.
LINK LED:
Lights up solid green when the
DUB-E100 has a good
physical connection to the
network.
Quick Installation Guide
DUB-E100
USB 2.0 Fast Ethernet Adapter
CD with Manual and Drivers
For detailed instructions on
TX/RX LED:
Flashes green when data is
transmitted/received at 100Mbps.
When data is transmitted/received
at 10Mbps the LED flashes amber.
2