Hendi 230718 Mode D'emploi page 7

Troubleshooting
If the appliance does not function properly, please
check the below table for the solution. If you are
Problem
Appliance doesn't work
Appliance makes a strange noise Motor worn out or jar damaged
Appliance emits an odd smell
The jar leaks or is otherwise
damaged
Extreme vibrations
Appliance doesn't cut evenly
The appliance only works when
puls switch is used
Electric diagram (mechanical control models)
On/Off
AC 220V
still unable to solve the problem, please contact the
supplier/service provider.
Cause
No power
Knife has been jammed
Appliance overheated
The jar is not placed on the
motor unit
Motor unit burnt
Worn out cutting unit
Worn out motor unit or jar
The knife is damaged
Power module is defective
Over load protection
Sensitive switch
Pulse switch
Solution
Check if the plug is connected to
mains.
Push the reset button on the
underside of the motor unit.
Remove the plug from mains and
let the appliance cool down
Switch the appliance of and place
the jar on the motor unit and try
again
Contact your supplier.
Contact your supplier.
Contact your supplier or replace
the jar with replacement set
933668.
Contact your supplier or replace
the jar with replacement set
933668.
Contact your supplier or replace
the jar with replacement set
933668.
Contact your supplier
Variable switch
Speed knob
Motor
Earth
7
EN