Michelin 92418 Mode D'emploi page 21

Gauge does not illuminate
Display fails to switch on when yellow button is
pressed
Display shows „LO"
Gauge appears to read incorrectly or is unreadable
Pumping but tyre is not inflating
Gauge does not display when tyre valve is con-
nected
SERVICE
Should you have any questions regarding commissioning or operating in spite of studying these operating
instructions, or if a problem should occur against all expectations, please get in contact with your specialist
supplier.
„ Check batteries are correctly inserted into tray.
„ Batteries flat - Replace with 2 x CR2032 or
equivalent.
„ Replace batteries (2 x CR2032 or equivalent).
„ When the tyre valve connector is attached,
before switching the unit on, ensure the gauge
is reading your current tyre pressure.
„ Disconnect from tyre for at least 5 seconds, or
until display goes off.
„ Press yellow reset button until display shows all
the digits then returns to 0.0.
„ Check that the tyre valve adaptor is correctly
fitted to tyre valve.
„ Ensure tyre valve is correctly connected to the
tyre valve adaptor.
EN
21