Michelin 92418 Mode D'emploi page 18

ANALOGUE FOOTPUMP
1. Analogue gauge reads in psi and bar
2. Ergonomic rubber tread plate
3. Rubber feet
4. Locking lever
5. 67 cm (approx) high pressure air hose with tyre valve connector
6. Adaptors (snap-in storage under display unit)
SPECIFICATIONS
Pressure accuracy
Pressure resolution
Hose length
TO OPERATE
1. Uncoil the high pressure hose (5) & screw tyre valve connector (5) to the tyre valve. When connected
correctly the gauge will display the current pressure in the tyre. If this is the tyre pressure as stated in your
vehicle's handbook you can simply remove the tyre valve connector (5).
2. To unlock the foot plate slightly depress the foot plate & twist down the yellow lock levers (4) & slowly
let the foot plate extend. To inflate push slowly & firmly on the foot plate until the desired pressure is
showing in the display.
3. Remove the tyre valve connector (5) from the tyre valve. Take care when unscrewing the tyre valve con-
nector.
4. To lock the foot plate in the closed position slowly push the foot plate down & twist up the yellow lock
levers (4).
5. Special adaptors (6) are provided to inflate sports balls, air beds, small inflatables etc. To avoid over-inflati-
on, always follow manufacturer's instructions on the items to be inflated.
If these operating instructions are not in the desired language on the specification plate, the accompanying
label in the respective language can be affixed onto this part.
18
+/- 1 psi up to 50 psi
psi & bar
67 cm (approx)