Michelin 92418 Mode D'emploi page 20

TO OPERATE
1. Press the yellow button (1) to turn on the display. Wait a few seconds until the display shows zero.
2. To choose a pressure format, psi, bar or kPa press the yellow button (1). Each press of the button cycles
through the pressure format.
3. To save battery power the gauge will automatically turn off after approximately 30 seconds if not in use.
4. Uncoil the high pressure hose (6) & screw tyre valve connector (6) to the tyre valve. When connected
correctly the gauge will display the current pressure in the tyre. If this is the tyre pressure as stated in your
vehicle's handbook you can simply remove the tyre valve connector (7).
5. To unlock the foot plate slightly depress the foot plate & twist down the yellow lock levers (5) & slowly let
the foot plate extend. To inflate push slowly & firmly on the foot plate until the desired pressure is shown
on the digital display.
6. Remove the tyre valve connector (6) from the tyre valve. Take care when unscrewing the tyre valve con-
nector.
7. To lock the foot plate in the closed position slowly push the foot plate down & twist up the yellow lock
levers (5).
8. Special adaptors (7) are provided to inflate sports balls, air beds, small inflatables etc. To avoid over-inflati-
on, always follow manufacturer's instructions on the items to be inflated.
If these operating instructions are not in the desired language on the specification plate, the accompanying
label in the respective language can be affixed onto this part.
TO REPLACE THE BATTERIES
The display will show „LO" when the batteries need replacing, to do this:
1. Pull out battery tray (as above) & remove old batteries.
2. Note that polarity for both is positive „+" upwards & replace with new CR2032 or equivalent.
3. Push back the battery tray, if correctly inserted display will illuminate to confirm this.
TROUBLE SHOOTING
20
Battery Tray
2x CR 2032
Pull Out