Cooktop Care; General Cleaning - Jenn-Air JGCP430 Guide D'utilisation Et D'entretien

Masquer les pouces Voir aussi pour JGCP430:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT: Before cleaning, make sure all controls are off and
the cooktop is cool. Always follow label instructions on cleaning
products.
Soap, water and a soft cloth or sponge are suggested first unless
otherwise noted.
EXTERIOR PORCELAIN ENAMEL SURFACES
Food spills containing acids, such as vinegar and tomato, should
be cleaned as soon as the entire appliance is cool. These spills
may affect the finish.
Cleaning Method:
Glass cleaner, mild liquid cleaner or nonabrasive scrubbing
pad:
Gently clean around the model and serial number plate
because scrubbing may remove numbers.
STAINLESS STEEL
Do not use soap-filled scouring pads, abrasive cleaners, Cooktop
Polishing Creme, steel-wool pads, gritty washcloths or abrasive
paper towels. Damage may occur, even with one-time or limited
use.
Rub in direction of grain to avoid damaging.
Cleaning Method:
Stainless Steel Cleaner and Polish:
Liquid detergent or all-purpose cleaner:
Rinse with clean water and dry with soft, lint-free cloth.
PORCELAIN-COATED GRATES AND CAPS
Food spills containing acids, such as vinegar and tomato, should
be cleaned as soon as the cooktop, grates and caps are cool.
These spills may affect the finish.
To avoid chipping, do not bang grates and caps against each
other or hard surfaces such as cast iron cookware.
Do not reassemble caps on burners while wet.
Do not clean in the Self-Cleaning cycle.
Do not clean in dishwasher.
Cleaning Method:
Nonabrasive scrubbing pad and mildly abrasive cleanser:
Clean as soon as cooktop, grates and caps are cool.
SURFACE BURNERS
Sealed Burner models
See "Sealed Surface Burners" section.

COOKTOP CARE

General Cleaning

CONTROL KNOBS
To avoid damage to the control knobs, do not use steel wool,
abrasive cleansers or oven cleaner.
To avoid damage, do not soak knobs.
When replacing knobs, make sure knobs are in the Off position.
On some models, do not remove seals under knobs.
NOTE: When replacing knobs after cleaning either the surface
burner controls or the grill module control, make sure the knobs
are replaced to the correct location. For example, the knobs for
the surface burner controls will read "LITE," while the knob for
the grill will read "LITE/HI."
Cleaning Method:
Soap and water or dishwasher:
Pull knobs straight away from control panel to remove.
CONTROL PANEL
To avoid damage to the control panel, do not use abrasive
cleaners, steel-wool pads, gritty washcloths or abrasive paper
towels.
Cleaning Method:
Soap and water.
Wash, rinse and dry with a soft cloth.
Glass cleaner and soft cloth or sponge:
Apply glass cleaner to soft cloth or sponge, not directly on
panel.
GRIDDLE MODULE
Clean the griddle shortly after removing food and the griddle has
cooled down.
Cleaning Method:
Hot, soapy water and/or plastic scrub pad
After cleaning dry surface with a paper towel
Drip Tray and Area Under Tray
Allow cooktop to cool completely before cleaning.
Cleaning Method:
Warm, soapy water or nonabrasive cleanser.
Damp cloth or nonabrasive pad.
Dry completely before placing drip tray in position.
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Jgcp436Jgcp536Jgcp548

Table des Matières