Audio Preset Recall; Demonstration Mode Setting - Kenwood KDC-X590 Mode D'emploi

Menu system
Function of the KDC-X590/KDC-MP632U
Other than Standby mode

Audio Preset Recall

Recalling the sound setup registered by <Audio
Preset Memory> (page 33).
1
Select the source
Press the [SRC] button.
2
Enter Menu mode
Press the [MENU] button for at least 1 second.
"MENU" is displayed.
3
Select Audio Preset mode
Push the Control knob towards [FM] or [AM].
Select the "A-PRESET" display.
4
Enter Audio Preset mode
Press the Control knob for at least 1 second.
5
Select the Audio Preset Recall
Push the Control knob towards [FM] or [AM].
Select the "RECALL" display.
6
Recall the Audio Preset
Press the Control knob for at least 2 seconds.
The "RECALL" display blinks 1 time.
7
Exit Audio Preset mode
Press the [MENU] button.
• The User memory of <System Q> (page 12) is
changed to the value which was recalled.
• The source tone memory item of <Audio Control>
(page 12) is changed to the value which was recalled
by the selected source.
34
|
English
In Standby mode

Demonstration mode Setting

Sets the demonstration mode.
1
Select the Demonstration mode
Push the Control knob towards [FM] or [AM].
Select the "DEMO" display.
2
Set the Demonstration mode
Press the Control knob for at least 2 seconds.
Each time you press the knob at least 2 seconds,
the Demonstration mode alternates between the
settings shown in the table below.
Display Setting
"DEMO ON" The Demonstration mode function is ON.
"DEMO OFF" Exit Demonstration mode (Normal mode).