Installation Instructions; Outdoor Sear Burner Installation - KitchenAid KBEU121T Instructions D'installation Et Guide D'utilisation Et D'entretien

WARNING
Excessive Weight Hazard
Use two or more people to move and install
built-in sear burner.
Failure to do so can result in back or other injury.
■
Unpack sear burner. Remove all packaging materials and
remove sear burner from carton.
■ Move sear burner close to desired outdoor location.
Make Gas Connection
Natural Gas Use
This installation must conform with local codes and ordinances.
In the absence of local codes, installations must conform with
either the National Fuel Gas Code ANSI Z223.1 - latest edition, or
CAN/CGA-B149.1 Natural Gas and Propane installation code.
1. Place sear burner into outdoor enclosure, but leave enough
room in back to connect to gas supply and plug in electrical
single-prong plug to sear burner.
WARNING
Explosion Hazard
Use a new AGA or CSA approved "outdoor"
gas supply line.
Securely tighten all gas connections.
Failure to do so can result in death, explosion, or fire.
2. A combination of pipe fittings must be used to connect the
sear burner to the existing gas line. If local codes permit, use
an outdoor flexible stainless steel tubing gas connector,
design-certified by CSA International, to connect the sear
burner to the rigid gas supply line. A ⁵⁄₈" diameter line is
recommended. Pipe-joint compounds suitable for use with
Natural gas must be used. Do not use TEFLON
†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.
8

INSTALLATION INSTRUCTIONS

Outdoor Sear Burner Installation

®† tape.
3. Using a wrench to tighten, connect the gas supply to the sear
burner. Use pipe-joint compound on all non-flared male
threads. Do not kink or damage the flexible connector when
moving the sear burner.
A
A. ½" (1,3 cm) sear burner gas pipe
B. New CSA International approved
"outdoor" flexible gas supply line
C. Rear of sear burner
D. To natural gas supply
4. Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A
A. Closed valve
B. Open valve
5. Test all connections by brushing on an approved
noncorrosive leak-detection solution. Bubbles will show a
leak. Correct any leak found.
Plug in Sear Burner
1. This built-in outdoor sear burner comes with a power
transformer plug assembly for the ignitor system. Plug in the
single-prong plug in the receptacle on the lower left-hand
side of the sear burner.
A. Single-prong plug
B
C
D
B
A