Technical Information - Bose B1 Bass Module Guide D'installation

English Dansk
Connecting one B1 bass module
Figure 3
Bass module connections
Connecting a second B1 bass module
Figure 4
Connections for two bass
modules

Technical Information

Deutsch Español
1. Plug one end of the B1 bass module cable into one of the B1 connectors (Figure 3).
Rotate the plug clockwise to lock it in place. Listen for a soft click to ensure the
connector is locked.
2. Plug the other end of the cable into the Bass Module Out connector on the power
stand. Rotate the plug clockwise to lock it.
Note: To disconnect a B1 cable, slide back the metal tab on the body of the plug, rotate the plug
counterclockwise and pull it out of the connector.
CAUTIONS:
• DO NOT connect a B1 bass module to two power stands at the same time.
• DO NOT connect any bass module other than the B1 to the power stand.
• Use only the supplied blue B1 bass module 4-wire cable to connect the B1 bass module
to the power stand. The power stand uses the signals on two of the wires to automatically
sense how many B1 bass modules are connected. DO NOT substitute the supplied cable
with a 2-wire speaker cable.
1. Plug one end of the second B1 bass module cable into the unused connector on the first
B1 bass module.
2. Insert the other end of the cable into one of the connectors on the second B1 module.
Dimensions: 15''H x 10¼''W x 17¾''D (38.0 cm x 26.0 cm x 45.0 cm)
Weight: 25.1 lb (11.4 kg)
Impedance: 8 ohms
This product conforms to the EMC Directive 89/336/EEC and to the Low Voltage
Directive 73/23/EEC. The complete Declaration of Conformity can be found at
www.Bose.com/static/compliance/index.html.
Français Italiano
To power stand Bass Module Out
TM
or PackLite amplifier OUTPUT
To power stand Bass Module Out
or PackLite TM amplifier OUTPUT
Nederlands Svenska
B1 B M
ASS ODULE
3